Once found, check with the ohmmeter from the topside to the bottom to be sure it is the right wire (you are looking for continuity). Be careful not to pull any pins out of the terminals while probing for the wire with continuity on the backside of the terminal. Turn the fuse block upside down and remove the bottom section of the fuse block. Cut or remove any device holding the harness to the fenderwell so that some slack will be available to turn the fuse block upside down. Remove the bolts holding the fuse relay box to the fenderwell. Remove the negative terminal to the battery. Once that is found, mark it or remember its location in the block, because that is the wire that the new lights will be hooked up to. Check the remaining terminals for continuity to the headlight connector. When a ground is found, remember which terminal it is. Put the voltmeter on ohms scale and remember which terminal was hot-do not touch this terminal while on ohms or it will blow the fuse in the voltmeter.
![winject 06 accord foglights winject 06 accord foglights](https://ae01.alicdn.com/kf/Hd323239c93634d789b2894bc8a516b07J/12V-H11-Pair-Fog-Light-For-Honda-Accord-2003-2004-2005-2006-2007-2008-Front-Foglight.jpg)
One terminal will have power all the time. Pull the relay out and test the terminals for power with a voltmeter (the key should be off).
![winject 06 accord foglights winject 06 accord foglights](https://cdn.shopify.com/s/files/1/0048/8629/8727/products/WJ30-0085-09-1_550x415.jpg)
Locate the high beam relay for the headlights. It is possible to hook the fog lights up to the main fuse and relay box under the hood, although the degree of difficulty is much greater. The switch in the car takes hardly any power or amps and turns the relay on or off. The other two posts on the relay are for switched power from a switch in the car, and the other post is simply a ground. This is the same as a light switch in the house, except that it is turned on and off remotely. These can be easily used with WINJET fog lights.There is a 10mm wire that goes from the battery positive terminal to one terminal on the relay and a wire from the relay to the lights. If you are picky about how your dashboard looks, you may want to go to the dealer (or a junkyard that has a Accord with fog lights) and purchase a stock fog light harness and switch.To prevent this (and for safety) you should disconnect the battery before installing fog lights onto your Accord, and reconnect the battery only after installation is complete
#WINJECT 06 ACCORD FOGLIGHTS INSTALL#
![winject 06 accord foglights winject 06 accord foglights](https://ae01.alicdn.com/kf/H6c6722d8f7374faf92942e0aea19e65ex/12V-Pair-Fog-Light-For-Honda-Accord-2003-2004-2005-2006-2007-2008-Front-Foglight-With.jpg)
#WINJECT 06 ACCORD FOGLIGHTS FULL#
And unlike the other non-dealer fog lights out there, Winjet Honda Accord Fog Light housings are backed by a full one year warranty against defects.įor this Winjet Honda Accord OEM Factory Style Clear Fog Light Kit, professional installation recommended. Winjet is a worldwide company who has been producing all kinds of fog lens for years, and they are the biggest company to specialize in OEM replacements. That's not to say that Honda Accord Winjet Clear Fog Lights are cheap in quality. For a heck of a lot cheaper than what the dealer charges, you can get the styling and safety of fog lens on your Honda Accord with money to spare for other upgrades. The big difference between Winjet and the dealer though, is PRICE. Like the fog lights you could buy from your local Honda dealer, Winjet Foglamps are designed to fit into the factory mounting position on your Honda Accord. Luckily for you, Winjet has been expertly making all kinds of aftermarket Honda fog lights for over a decade. Outside of going to the dealer, there are not too many other places you could find a set of OEM style fog lights for your Honda Accord. There are not a lot of companies out there that make vehicle specific fog lamps.